Roborock Saros 10R Robot Vacuum and Mop

Model details

Additional useful information

Roborock Saros 10R owners can use this exact-model guide to verify the published configuration, complete setup, choose operating modes, perform routine care, isolate common failures, and avoid applying parts or instructions from a nearby sibling.

Roborock Saros 10R is the exact Saros 10R Robot Vacuum and Mop covered here. It is a 3.14-inch-low flagship robot built around StarSight 2.0 navigation, a split DuoDivide main brush, an AdaptiLift chassis, and Multifunctional Dock 4.0.

Published configuration: The Saros 10R body is 3.14 inches high because Roborock uses its StarSight Autonomous System 2.0 instead of a raised laser turret. StarSight 2.0 combines 3D time-of-flight sensing with an RGB camera for navigation and obstacle recognition. The DuoDivide main brush uses two short rollers that feed debris toward the central suction inlet. A FlexiArm Riser side brush and an extending edge mop reach room edges while lifting when the cleaning mode requires it.

Setup, operation, and troubleshooting: Seat both DuoDivide rollers, the FlexiArm side brush, and the correct mop hardware before creating the first StarSight map. Define carpet behavior before enabling unattended mixed-floor runs. If the 10R misses a narrow obstacle, clean the front 3D and RGB sensor windows rather than looking for a LiDAR turret. For dock faults, inspect clean-water supply, dirty-water seating, the wash tray, mop attachment, and selected drying duration before remapping.

Maintenance and model boundaries: The AdaptiLift chassis can raise sections of the robot to cross transitions and adjust brush or mop contact. The main brush, side brush, and mop assemblies can lift independently for different floor types. The Multifunctional Dock 4.0 washes the mops with water heated to 176 degrees Fahrenheit. Dock hot-air drying can be set for two, three, or four hours. The dock supports intelligent rewash and remop when its dirt assessment calls for another pass. The mop system lifts 17 millimeters to reduce wet contact on carpets. Match dust bags, filters, main and side brushes, mop hardware, detergent, and dock-service parts to Roborock Saros 10R; stations and consumables from a nearby robot or dock generation are not interchangeable unless the manufacturer explicitly lists both.

• The main brush, side brush, and mop assemblies can lift independently for different floor types.
• The Multifunctional Dock 4.0 washes the mops with water heated to 176 degrees Fahrenheit.
• Dock hot-air drying can be set for two, three, or four hours.
• The dock supports intelligent rewash and remop when its dirt assessment calls for another pass.
• The mop system lifts 17 millimeters to reduce wet contact on carpets.