Ultraloq U-Bolt Pro WiFi Smart Lock

Model details

Additional useful information

Use this Scanual guide to identify Ultraloq U-Bolt Pro WiFi Smart Lock, follow official setup and reset guidance, and match power, radio, mounting, hub, and regional accessories to model U-Bolt Pro WiFi.

ULTRALOQ U-Bolt Pro WiFi is a keyed fingerprint and keypad deadbolt with built-in 2.4GHz Wi-Fi, Bluetooth, four-AA power, DoorSensor, and no external bridge requirement.

Setup: Measure door bore, backset, thickness, and clearances; install the latch and cable, add four AA cells, hand/calibrate the bolt and DoorSensor, then join built-in 2.4GHz Wi-Fi in Xthings Home.

Reset: Use the bottom reset opening for about ten seconds until the lock confirms, then remove stale app ownership and rebuild users, fingerprints, codes, Wi-Fi, integrations, handing, and DoorSensor calibration.

Troubleshooting: For fingerprint misses, clean and re-enroll. For jams or drain, align the strike and test open-door travel. For offline status, replace batteries and verify 2.4GHz signal before resetting.

Compatibility and ecosystem boundary: This row is the built-in Wi-Fi U-Bolt Pro, not a Bluetooth-only model bundled with an external Bridge. The IP65 claim applies to the exterior, not the indoor battery assembly.

Maintenance and accessory matching: Use four matched alkaline cells, exact installation parts, and the correct thick-door kit only when measurements require it. Emergency micro-USB is a temporary entry aid, not a charging port.

Published checkpoints: Product: U-Bolt Pro WiFi built-in-Wi-Fi variant. Network: built-in 2.4GHz Wi-Fi. Local radio: Bluetooth. Bridge requirement: no separate U-tec bridge for this Wi-Fi variant. Access: fingerprint, keypad code, app, auto-unlock, and concealed physical key. Fingerprint capacity: up to 100 fingerprints under current product specification. Power: four AA alkaline batteries providing 6V nominal pack voltage. Emergency power: exterior micro-USB provides temporary power but does not charge batteries. Weather: exterior assembly IP65; interior assembly remains protected indoors. DoorSensor: included sensor needs position calibration. Door prep: bore, backset, thickness, and optional thick-door kit must match published range. Reset: bottom reset opening held about ten seconds until confirmation, then re-onboard.

• Fingerprint capacity: up to 100 fingerprints under current product specification
• Power: four AA alkaline batteries providing 6V nominal pack voltage
• Emergency power: exterior micro-USB provides temporary power but does not charge batteries
• Weather: exterior assembly IP65; interior assembly remains protected indoors
• DoorSensor: included sensor needs position calibration
• Door prep: bore, backset, thickness, and optional thick-door kit must match published range
• Reset: bottom reset opening held about ten seconds until confirmation, then re-onboard