Philips Hue Tap Dial Switch
Exact model Tap Dial Switch
Also identified as: Hue Tap Dial Switch, 046677578770, 046677578800
Philips Hue Tap Dial Switch is an indoor battery Zigbee controller with four programmable buttons and a rotary dimming dial, requiring Hue Bridge for its complete behavior.
- Product
- Hue Tap Dial Switch
- Protocol
- Zigbee
- Power
- one CR2032 lithium coin cell
- Controls
- four programmable press buttons
- US product numbers include 046677578770 black and 046677578800 white packages
First time using a Scanual? Read the quick guide.
Information checked August 27, 2026. Confirm critical specifications with the manufacturer.
Official resources
Manuals and official support
Replacement parts and accessories
Products for Philips Hue Tap Dial Switch
Confirm your exact model number, the current product listing, included parts, and return terms before ordering.
No curated products are currently listed for this model.
Use the official resources above for support and check back as the product resource list is reviewed and updated.
Model details
Additional useful information
Use this Scanual guide to identify Philips Hue Hue Tap Dial Switch, follow official setup and reset guidance, and match power, radio, mounting, hub, and regional accessories to model Tap Dial Switch.
Philips Hue Tap Dial Switch is an indoor battery Zigbee controller with four programmable buttons and a rotary dimming dial, requiring Hue Bridge for its complete behavior.
Setup: Install the CR2032, add Tap Dial under Hue accessories, assign each button and the dial to the intended rooms or zones, test direction and steps, then mount its plate.
Reset: Hold the rear setup pin until the status LED signals reset, remove any stale Hue accessory entry, and pair it again close to the bridge.
Troubleshooting: Replace the battery, verify LED response and Zigbee range, confirm the dial's assigned zone, and test in Hue before diagnosing a third-party ecosystem that may omit dial events.
Compatibility and ecosystem boundary: Tap Dial requires Hue Bridge for full operation, and Philips Hue explicitly excludes its rotary dial from Matter support. Generic Matter button expectations therefore do not establish dial compatibility.
Maintenance and accessory matching: Use one CR2032 and an exact Tap Dial mount. Preserve rear setup and battery access, and keep the controller indoors away from condensation.
Published checkpoints: Product: Hue Tap Dial Switch. US product numbers include 046677578770 black and 046677578800 white packages. Protocol: Zigbee. Power: one CR2032 lithium coin cell. Controls: four programmable press buttons. Dial: rotary dimming control. Hub requirement: Hue Bridge for full programming and dial behavior. Mounting: magnetic remote with wall plate. Placement: handheld, wall plate, or magnetic surface indoors. Setup: add as Hue accessory and assign buttons and dial. Reset: hold rear setup control until LED confirms. Matter boundary: Hue documents that the Tap Dial rotary dial is not supported through Matter.
- Dial: rotary dimming control
- Hub requirement: Hue Bridge for full programming and dial behavior
- Mounting: magnetic remote with wall plate
- Placement: handheld, wall plate, or magnetic surface indoors
- Setup: add as Hue accessory and assign buttons and dial
- Reset: hold rear setup control until LED confirms
- Matter boundary: Hue documents that the Tap Dial rotary dial is not supported through Matter
See something wrong? Report an error
Report a broken official link, a seller-listed item that does not match, or another factual issue. Scanual reviews requests but does not provide urgent or manufacturer support.